User Manual

46
11.4.2 Setup and Configuration
Before attempting to connect to a computer, the 9832B/9833B AC Power Sources must be
properly configured from the front panel and connected using phase sync adapter modules.
See the 3-Phase Operation section above for instructions.
On the front panel, set each AC source to ‘USBVCP’ in the communication settings.
Figure 40 - Communication Setup
Press the arrow keys (▲ ▼) to move the cursor to the wanted configuration. Press the
ENTER key to change its value and then press the ENTER key again to confirm the
changes.
11.4.3 Three-Phase Application Mode
After following the configuration steps you can now connect the 9832B/9833B AC Power
Sources to your computer using a standard USB communication cable.
Each AC Source must be connected to your computer or USB hub independently as shown:
Phase control software requires a USB COMM connection, and does not support RS232
connections.
Computer/USB hub