User Manual

35
Table 15 - Error Code Definitions
9.4 System Next
The System Next page is used to access to system defaults and calibration functions.
Figure 33 - System Next Page
9.5 Recall Default
Press System softkey, then press Next softkey to go to the next function page. At the System
Next screen press Recall Default softkey. Press an arrow key (▲ ▼) to move the cursor to
Reset all config? Press ENTER key, then press the Yes softkey to reset all configurations.
Figure 34 - Recall Default
Config 1(2) Field
Value
Volts (rms)
50
Volts (DC)
0
Freq (Hz)
60
Sync source
Phase
Phase (deg)
0.0
Range(V)
300
Couple
AC
Power On State
Off
(User) On/Off State
Off
(User) Volts(rms)
0
(User) Volts(dc)
0