User Manual

31
Press the arrow key (▲ ▼) to move the cursor to the wanted configuration. Press
ENTER key to change its value, then press ENTER key to confirm.
Figure 29 - Configure Limits
Move the cursor to Volts (rms). Use ▲ ▼ keys (or Rotary knob) to set the value of Volts
(rms) limit and other configurations. Then press OK or Enter key to confirm this setting.
Use ▲ ▼ keys (or Rotary knob) to select other configurations.
NOTE: If the output exceeds the limit value the Instrument will stop and the output will display an error
message. Press the Esc key to close the message window.