User Manual

8 Configure Menu

In Setting and Measure page, press Configure key to open the Configuration page. The

Configuration page includes three softkey options:

1. Config 1 (default)

2. Config 2

3. Limits

Each of these pages will be explained below with more detail.

Figure 26 - Default Configuration 1 Menu

8.1 Config 1

Configurations listed below can be edited in this Configuration 1 page.

Configurations

Range

Description

Range

150 V, 300 V

Select the range of AC output voltage

Couple

AC, DC or

AC+DC

Select the coupling of output voltage

Power On State

OFF, LAST, USER

OFF: When power on, the output is OFF.

LAST: When power on, the settings will

restore to the pre-shutdown state.

USER: When power on, users need to set the

output value and status. (Volts(rms),

Volts(DC), Freq, Sync Source )

Inrush Current

Measurement

Time (ms)

0 to 10000 ms

Set the time interval to measure Inrush

current

Inrush Current

Delay Time (ms)

0 to 10000 ms

Set the delay time to measure Inrush current

Table 11 - Config 1 Configurations