User Manual

85
1. Press , then to enter PROGRAM MODE. The
following screen will be displayed:
2. Use the keypad to select the program number where the
sequence is stored. Valid number is 1 – 10. Press to
confirm the program.
3. Press ( or for dual channel models) to
enable the output and execute the programmed sequence.
For dual channel models, both outputs will turn ON.
4. To disable the sequence at any time, press
( or for dual channel models) again. This will also
turn OFF the output. For dual channel models, both outputs
will be OFF.
3.12 External Analog Control
The power supply output(s) can be controlled by external DC voltage
sources (0 – 5 V or 0 – 10 V) or resistances (0 – 5kΩ). The
optional DIO/Analog Card must be installed for this function to
be available.
PROGRAM NUMBER = 0
PROGRAM OFF
Menu
5
Enter
OUTPUT
CH1
CH2
OUTPUT
CH1
CH2