User Manual

4. Place the two screws to tighten and secure the installed card.

5. Connect the power cord and turn on the power supply. The

newly installed card will be detected during boot up, indicated

next to S1: or S2: (depending on which slot the card is

installed into).

Removing Interface Cards

1. Power off the instrument and disconnect the AC power cord

in the rear panel. Remove the two screws on each side of

the installed interface card.

2. Use a flat blade screwdriver to gently pry the left and right

side of the interface card plate. When there is enough room,

use the screwdriver to pry the top part of the card until the

card has slid out with enough room to pull out the card by

hand.

3. Be sure to ground yourself before pulling out or touching any

parts of the printed board on the interface card.