User Manual
24
2. Make note of the metal notches that indicate where the card
should slide into. Inside the slot, there are two rails (left and
right side) where the card should slide smoothly into. The
very back of the slot is a 48-pin female connector that should
connect with the 48-pins on the back of the interface card.
3. The interface card should go right below the metal notches
on both sides and fit in between the inner card rails, also on
both sides. Slide the card down carefully. When it touches
the 48-pin connector, slowly push the card all the way in until
the panel of the interface card aligns with the rear panel of
the power supply.
S1
S1
: : : : : : : : : : : : : : : : : : : : : :
Metal
notch
Card
rail
48-pin female connector
Interface card