User Manual

180
External Analog Input Calibration
This calibration option is only available if the optional DIO/Analog
Interface Card is installed in the power supply.
Follow the steps below to proceed with external analog input
calibration.
1. From the calibration menu, press to enter EXT. INPUT
CALIB. If the single channel DIO/Analog Interface Card is
installed, then Figure 34 will be shown. If the dual channel
version is installed, Figure 35 will be displayed.
Figure 34- Single Channel External Analog Input Calibration
Calib EXT . Lo Volt = 1 . 000 V
Calib EXT . Lo Volt = 9 . 000 V
CH 1 EXT . VOLT Res = Start
CH 1 EXT . CURR Res = Start
3