User Manual

5. Set to 12V for the 12V test system and 24V for the 24V test system.

6. Use the key to select the profile of 1 / 2 / 3 / 4(12 V only) and use keys to

toggle between the four options.

7. Use the key to select Repeat and press . This option allows the user to repeat

the profile up to 100 times. Once a value is selected, press to confirm.

8. Use the key to select Delay and press . This option allows the user to delay the

repeated profile up to 100 seconds. Once a value is selected, press to confirm.

9. Use the key to select Off/On and use keys to toggle between the two options.

Choose On to be able to run the function.

10. Once both parameters are set, press to confirm the changed settings and press

several times to exit the menu. If the Starting profile function was setup properly,

the Trig indicator will be highlighted and Starting profile will be shown on the front

panel, shown below.

11. To enable the Short voltage drop function, press the key, on the front panel. The

proper voltage (12V or 24V) should be metered on the front panel display.

12. To run the Starting profile function press and to trigger the test to run.

13. Repeat step 8 to trigger the function to run as many times as needed or setup the

repeat functionality.

Note: If any automotive testing is running the will blink to indicate so. To stop

any test from running further, press and .

0.000V 0.000A

0.0W Starting profile

Trig

ISO16750-2 profile

Starting profile