User Manual

47
1. From the LIST menu, use the key to select Recall and press . The display will
say RECALL LIST with the prompt Recall List File: to ask to enter a number.
2. This is the location number where the program is stored in. Select a number between 1
to 10 with the current adjust knob or the numeric keypad, then press .
3. The display will return back to the LIST menu.
Run Program
To run a program sequence after it is recalled, the trigger source must be configured first. Refer
to “Configure Trigger Source” in section 3.3 to set up the trigger source.
Follow the steps below to run the program:
1. Assuming the stored program has already been recalled, from the LIST menu, with Off
selected, press . The Trig indicator will appear at the top middle of the display.
2. Now, press twice to exit the menu. The following will display:
3. If the display is showing the measured voltage and current value, the backlight
should be lit and display should show 0.000V and 0.000A.
4. Now, press the key to enable (ON) the output.
5. If the Trigger Source configured in section 3.3 is set to Manual (Def), then the front
panel trigger key can be used to initiate the program. Press and then .
6. The program will immediately start running and the backlight of the button will
be blinking. The Trig indicator will also disappear.
7. When the program ends, the will stop blinking and the Trig indicator will
reappear again.
Note: If the Trigger Source is configured to BUS, use the remote command for sending
triggers over any of the remote interface available. Refer to the programming
manual for details.
0.000V
0.000A
0.0W
OFF Trig
LIST