User Manual

3. This parameter is configured to limit the maximum power of the program (list) when it is

executed. Leave it default to 1200.0 for maximum power output. Press and the

following will display:

4. The display prompts the user to enter the number of times to repeat the program (list).

For this example, enter 5 with the numeric keypad and then press .

Note: The maximum number of repeat times is 65535 times.

5. The next display will show the following:

6. This is similar to step 5 and 6 in the previous section for Configure Sequence

Parameters. Each of the numbers on the display represents the sequence numbers

stored in memory, with “0” representing sequence # 10.

7. In this example, only sequence #1 and sequence #2 will be executed. Therefore, use the

numeric keypad and press 1 and 2 so that both of those numbers on the display will

toggle to “Y” in their places like the following:

FILE

Active Seq: 0987654321

EDIT LIST REPEAT

List Repeat = 1

EDIT LIST POWER

List Power = 1200.0W