User Manual

35
Reference Voltage
A 10 VDC reference output is available on REF_10V (pin 21) and Ground (pin 9).
Note: These pins are used for reference only and are not designed to power devices. Do
not connect a load across it.
Configure Voltage Limit
The minimum and maximum set voltage can be configured on the power supply to limit the
settable voltage range for protection.
Note: At any time during operation, when you are unable to set to a desired voltage,
check this voltage limit setting to make sure the set value is within range.
Follow the steps below to configure the voltage limits:
1. From the CONFIG menu, browse and select Limit and press . The following
screen will display:
2. With Vmin prompted, use the voltage or current adjust knob or the numeric keypad to
enter the minimum voltage limit value.
3. When finished, press , and the display will prompt with Vmax.
4. Enter the maximum voltage limit value the same way as in step 2.
5. When finished, press . The screen will return to the CONFIG menu.
6. Press several times to exit the menu.
Voltage Range
Vmin = 0.000 V