User Manual

51
Save/Recall a Measurement Configuration
The following measurement parameters will be saved or recalled during this
operation.
Table 5.1 – Save/Recall Parameters
Measurement state of single measurement, bin
function, or sweep function
Primary measurement of C, L, R, Z, and DCR
Secondary measurement of D, Q, R, G
Test frequency
Test level
Test range
Test speed
Display normal or large
Display notation
Primary digit
Secondary digit
Bin mode of tolerance or absolute
Bin display of bin, table or histogram
Bin beep of off, pass or fail
Bin swap of primary and secondary
Bin nominal value of tolerance mode
Bin comparator on/off switch of bin 1-9 and secondary
bin in tolerance mode
Bin high/low limits of bin 1-9 and secondary bin in
tolerance mode
Bin comparator on/off switch of bin 1-9 and secondary
bin in absolute mode
Bin high/low limits of bin 1-9 and secondary bin in
absolute mode
Sweep display of linear or logarithm
Sweep start frequency
Sweep stop frequency
Sweep high value of the graph scale
Sweep low value of the graph scale