User Manual

 Current Subnet Mask

 Current Gateway

Clear Errors

In this menu page, the user also has the ability to clear any errors, as

indicated in the bottom right corner of the screen with a red “ERR”, which

may occur. To do so, press the CLEAR ERROR option softkey to clear all errors.

This has the same effect as sending the “*CLS” command (see SCPI Common

Commands section) remotely.

Set to Factory Default

To set instrument settings to factory default, press the RESET option softkey.

The instrument will change all settings to default and the screen will return to

the main measurement display.

Below is a table of the factory default settings:

Table 4.1 – Default Settings

Parameter

Default Setting

Mode

Measurement

Primary measurement

Parallel Capacitance (Cp)

Secondary measurement

Dissipation Factor (D)

Test frequency

1.000 kHz

Test level

1 VRMS

Test range

Auto

Test speed

Slow

Display font

Normal

Display notation

Decimal

Primary digit

Secondary digit

Bin mode

Tolerance

Bin mode display

Bin

Bin beep

Off