User Manual

There are many parameters that may be configured for each sweep. The

following table are the different parameters that can be setup in the Sweep

function.

Table 3.8 – Sweep Parameter Selections

Parameter

Description

Input

FUNC

Specify the type of sweep measurement

All

combinations

(Except DCR)

LEVEL

Specify the sweep voltage level

0.5 VRMS, 1

VRMS

START

Specify the sweep start frequency (X-Axis)

20 Hz to 300

kHz

STOP

Specify the sweep stop frequency (X-Axis)

20 Hz to 300

kHz

Specify the high display value scale (Y-Axis)

LOW

Specify the low display value scale (Y-Axis)

STEP

Specify the frequency sweep step and limit

number of measured points

1, 2, 5, 10

SWAP

Specify primary or secondary sweep

measurement

PRI, SEC