User Manual

32
Configure Bin Function
The following table shows the different parameters that can be configured in
the Bin function.
Table 3.7 – Bin Parameter Options
Parameter
Description
Input
FUNC
Specify the measurement type
All combinations
NOM*
Specify the nominal component value
Valid component
range
FREQ
Specify the test signal frequency
20 Hz to 300 kHz
LEVEL
Specify the test signal level
0.5 VRMS, 1
VRMS, 1 VDC**
RANGE
Specify the measurement range control
AUTO, HOLD
SPEED
Specify the measurement speed
SLOW, FAST
SWAP
Specify primary or secondary
measurement
PRI, SEC
*Tolerance mode only
**DCR measurement only
To perform the bin function, press the BIN function key to enter the bin
softkey menu. The default mode is tolerance mode.