User Manual

21
3.4 Configure Basic Measurement
If the component under test is a capacitor, make sure the
capacitor has been fully discharged before connecting it to
the instrument. Failing to discharge the capacitor may
damage the instrument and will be considered misuse.
To measure the component, connect the device under test to the test leads or
insert it into the test fixture. Press MEAS FUNC to select desired primary
measurement of C, L, Z, R or DCR. To select series or parallel mode as well as
the secondary measurement parameters of Q, D, R, G, θ (not shown), and X
(not shown), press the corresponding softkey to the right of the LCD.
Figure 3.10 – Measurement Function Display
Primary Parameters
All primary parameters are listed below:
Primary
Measurement
Secondary
Measurement
Measurement
Parameters