User Manual

GPIB

The load can be configured with a GPIB address from 0 – 31. To communicate via GPIB, connect

a GPIB cable to the GPIB interface on the rear panel, as illustrated below.

USBTMC

The device is SR1, RL1, and DT1 enabled. It can receive the following request:

REN_CONTROL, GO_TO_LOCAL, LOCAL_LOCKOUT. When it receives MsgID = TRIGGER USBTMC

command, it will transmit TRIGGER command to the function layer.

4.2 Remote Commands

The instrument supports some SCPI commands and some instrument specific commands. These

commands enable a computer to remotely communicate and control the instrument over any

of the supported remote interfaces: USBTMC, RS-232, and GPIB.

Refer to the programming manual for details, which can be downloaded from