User Manual

5. Press to continue. The display will show the following:

SEQ01 will be shown if sequence 1 is activated. Otherwise, it will display SEQXX where

XX is the first sequence number in the program that is activated (starts from 1-9 and

then 0).

The load is prompting to enter the On Time for the sequence number in seconds. This is

the length of time in which to run the sequence with input enabled (ON). Valid range is

0.0 s – 60.0 s. Use the numeric keypad or rotary knob to enter a value. Then press

6. Now, the load will prompt to enter Off Time. This is the length of time in which to run

the sequence with input disabled (OFF). Valid range is 0.0 s – 60.0 s. Use the numeric

keypad or rotary knob to enter a value. Then press .

7. The load will then prompt to enter P/F Delay Time. This is delay time is illustrated by

the graph below:

EDIT PROGRAM

SEQ01 On Time = 0.0 S

EDIT PROGRAM

Short Sequence = □□□□□□4Y2Y