User Manual

7. Press and it will prompt to enter the slew rate of the step. If High-Rate was

selected earlier, units will be in A/us. Otherwise, it will be in A/ms.

8. Press and it will prompt to enter the step with. Valid range is 20 us – 3600 s.

Enter a value and then press to continue.

9. The load will prompt to enter parameters for the next step. Follow steps 6-8 to enter

the values for the step’s parameters. Once all steps’ parameters are entered, the load

will prompt for the Repeat Count, which sets how many times to repeat the list

program. Valid range is 1 – 65535. Press to continue.

10. The load will prompt to select the memory location to store the list parameter

information. There are seven total save locations. Enter a value between 1 and 7, then

press to confirm. The display will return to the List menu.

Note: If List mode is enabled, the Edit menu will be locked and list parameters cannot be

changed until List mode is disabled.

EDIT LIST

Step 001 Width = 0.00002S

EDIT LIST

Step 001 Rate = 0.0001A/us

EDIT LIST

Step 001 Level = 0.0000A