User Manual

Note: The RMT indicator will appear on display when the instrument is successfully connected

to a PC remotely through any remote interface. Keys on the front panel will be locked until the

instrument is in LOCAL mode. To return to LOCAL mode from the front panel, press

( and then ) . The RMT indicator will disappear when the instrument is in LOCAL

mode.

From the SYSTEM menu, browse and select Communication and press . The following

screen will appear.

RS-232

Follow the steps below to configure the instrument for RS-232 operation:

1. Select RS-232 and press to set to RS-232 for remote communication. The

following display will be shown:

2. 4800 is the baud rate; 8 is the data bits; N is the parity; 1 is the stop bit; Addr… is for

address.

3. Use the and ( or ) keys to select between each serial settings, and use

( or ) keys to change the settings.

4. The following setting options that can be used:

Baudrate: 4800, 9600, 19200, 38400, 57600, 115200*

Data bits: 8

RS232

4800 , 8 , N , 1 , NONE

COMMUNICATION

RS232 USBTMC GPIB