User Manual

Configure CW Parameters

There are several parameters that should be set up prior to operating in CW mode. Press

so that it lights up, then press ( )and to access Setup for CW

mode. The setup menu will be shown:

The setup parameters are: Range, High (Voltage limit), and Low (Voltage limit). Use the

( or ) keys to select each parameter, and use the numeric keypad to change the

value. Press to confirm the change.

Range

Use the numeric keypad to change the range. This value will also act as a limit to how much

power the load can be configured to. The adjustable ranges vary depending on the model. See

specifications for details.

High

This parameter refers to the voltage high limit for the automatic test mode. During automatic

test mode, the device under test (DUT) must be operating below the configured value for the

Constant Power

Range=250.00W