User Manual
24
Figure 6.1 List Mode Current Waveform
6.4.1 Congure List
Lists are run exclusively from internal memory only. As in other menus, an active eld is denoted by an underline cursor
or ashing. To enter a list into memory, complete the following:
1. Press + .
2. Set the rst eld in the menu to “OFF”. If the eld is set to “ON”, press to change the value to “OFF”.
3. Move the selected eld via the buttons to the “EDIT” (shown as EDI) eld and press to start editing a
List. If nothing happens, ensure the rst eld is set to “OFF”.
4. Set the current range.
5. Set the number of steps in the list. This is a value between 2 and 84.
6. Set the rst step’s current, slew rate, and step time.
7. The next step in the list will prompt automatically. Enter the values for each step in the same way.
8. When each step is entered, the system prompts for the number of times to run the sequence. A 1 in this eld means
the sequence will run only once.
9. Enter the list le location to store the newly created list.
The list is now saved and may be recalled.
6.4.2 Run List
1. Select the list to run:
1. From the “List” menu, select “CALL” and press .
The load prompts for the list to recall (1 through 7).
2. Enter the list number and press to recall it.
2. Enable List mode by selecting the “O” menu item and press .
The “OFF” changes to “ON” and the “Trig” indicator lights.