User Manual

Battery Capacity Analyzer User Manual

6.1 Equipment

AnadjustableDCpowersupplyisrequiredtocompletethecalibration.Thepowersupplymustbecapableof32volts

and12ampswithprogrammingandreadbackresolutionwithaminimumoftwodigitstotherightofthedecimalpoint.

TheB&KPrecisionModel9202isrecommend.

To start the calibration process:

1. Connectthe603Btothespeciedpowersupply.The603Busesathreewireconnectionforbothpositiveand

 negativecables.Bothsidesofthealligatorclipmustmakeagoodconnectiontothepowersupplyterminals.

2. Setthepowersupply12.000voltsand2.000A

3. Enablethepowersupplyoutputandverifythe603Bpowersup.Thedisplayedvoltageisshouldbebetween9to

 13voltsastheunitisnotcalibratedatthispoint.

4. PressthebuttontoselecttheMainMenu.

5. Usethebuttonstomovethepointertothelastrowcalled“Calibration”andpressthebutton.The

password screen will be displayed.

6. Thepasswordis13579.Thecursorwillbelocatedattherstdigitofthepassword.Usethebuttonsto

 incrementthisdigitto1andpressthebuttontomovetothenextdigitandincrementthisdigitto3.Proceedin

 completeallfordigitsuntil13579isshowinginthiseld.

7. Pressthebuttontoproceed.The603Bwilldisplaythethreepartcalibrationscreen.Thepointerwillbelocated

 ontherstrow“VoltageCalibration”.

8. Pressthebuttontoproceedtovoltagecalibration.

Calibration

SOC Prof ile Setting

SOC Table Selection

Back Light On

Calibration screen

ENTER to Un lock

PASSWORD : 00000

Passwordscreen

Voltage Calibration

Current Calibration

Load Calibration

Voltagecalibration

6 Calibration Procedures

Thecalibrationsectiondescribestheprocessandequipmentneededtocalibratethe603B.Thecalibrationprocessis

madeupofseveralsections.Allsectionsshouldbecompetedinfull.Readtheentercalibrationsectionbeforeattempting.