User Manual

Battery Capacity Analyzer User Manual
12
3.2 Quick Test Mode - Charger Circuit Test
SimilartotheotherQuickTestmodestheChargerCircuittestisatooltohelpevaluatetheperformanceofthecharger
circuitunderanopenandloadedcondition.BoththeopenvoltageOCVandLCVvaluesaredisplayed.Theloadapplied
isbasedontheAhvalueenteredandiscalculatedtoplacealightloadthatshouldbewillwithinthenominalrangeofthe
chargercircuit.Althoughthe603Bdoesnottest24voltbatteriesitcantestmost24voltchargercircuits.
AnadapterisprovidedwithanF1tabononeendandF2tabontheother.Usingthecorrectlysizedtab,plugoneendof
the adapter into the leads of the system charger circuit. The other end of the adapter is used for an attachment point for
the603Btabtype,alligatorclips.
Charger adapter
1. Connectthe603BcablesandverifythepositiveandnegativeleadsarecorrectandtheReversePolarityLEDisnot
illuminated.
VO = 12.78 Volts
Quick press [TEST]
or
Main press [ENTER]
BATTERY QUICK TEST
VO : 12. 77 SOC : 90
VL : 12. 28
IR : 24m RS : N/A
3. Pressthebuttontoaccessthe<CHARGERQUICKTEST>mode
CHARGER QUICK TEST
OCV : 13. 61 Ah : 007
LCV :
Press TEST or CANCEL
Cursor
2. PressthebuttontomovetotheQuickTestmenu.
Thecursor(underline)willbelocatedintheAh:eld.
4. UsebuttonstoincreaseordecreasetheAh:valueuntilitmatchesthebatteryundertestAh.