User Manual

40
7. Press (ENTER) to confirm the selection. The message “SAVED” will be displayed to show
that the change is now in effect. The multimeter will exit the parameter level and move up a level to
the command level.
8. Press → key to exit from the menu and return to the measurement status.
4.5.4 Key Sound
The multimeter has a key sound function and you can enable or disable it. The key sound state is
stored in non-volatile memory and does not change when power has been off after a reset.
Note: Factory default key sound is enabled.
Use the following steps to change key sound setting:
1. Press → to enter the menu on the menu level, “A: MATH MEU” will be displayed.
2. Use or key to move across to the SYS MEU on the menu level, “C: SYS MEU” will
be displayed.
3. Press to move down to the command level within the SYS MEU, “1: BEEP STA” will be
displayed.
4. Use or key to move across to the KEY SONG command, “5: KEY SONG” will be
displayed.
5. Press to move down a level to enable or disable the key sound.
6. Use or key to turn ON or turn OFF the key sound.
7. Press (ENTER) to confirm the selection. The message “SAVED” will be displayed to show
that the change is now in effect. The multimeter will exit the parameter level and move up a level to
the command level.
8. Press → key to exit from the menu and return to the measurement status.