User Manual

Utility Function 74
13.24 Channel Tracking
When the track function is enabled, by changing the parameters or states of CH1, the corresponding parameters or states
of CH2 will be adjusted to the same values or states automatically. At this point, the dual channels can output the same
signal.
Choose Utility → CH Copy Coupling → Track to enable or disable the track function. When the track function is enabled,
channel copy and coupling functions are disabled; the user interface is switched to CH1 and cannot be switched to CH2,
as shown in the following gure.
Figure 13.16 Track Interface
Press PhaseDev to enter the following interface. Then use the numeric keyboard or knob and arrow keys to input the
desired value for the phase deviation between CH1 and CH2. The resulting signal is represented by:
Phase
CH2
-Phase
CH1
=PhaseDev.
Figure 13.17 Phase Deviation Interface