User Manual
Utility Function 71
Note: The Sync signal related to the waveform is not inverted when the waveform is inverted.
13.21 EqPhase
Press Utility → Output Setup → EqPhase to align the phases of CH1 and CH2.
Choosing the menu will re-congure two channels and enable the generator to output with specied frequency and start
phase. For two signals whose frequencies are the same or a multiple thereof, this operation will align their phases.
13.22 Waveforms Combination Mode
The CH1 output port of the 4060B Series outputs the waveform of CH1 in the general mode, while the waveform of
CH1+CH2 can be output in the combined mode. Similarly, the CH2 output port of 4060B Series outputs the waveform
of CH2 in the general mode while the waveform of CH1+CH2 can be output in the combined mode.
Press Utility → Output Setup → Wave Combine to enter the waveforms combining interface, as shown in the following
gure.
CH1 Switch Output the waveform of CH1.
CH1+CH2 Output the waveform of CH1+CH2.
CH2 Switch Output the waveform of CH2.
CH1+CH2 Output the waveform of CH1+CH2.
Return Save the current operation and exit the current interface.
Note: When the waveforms combining function is enabled, the load of two channels will be set to the same automat-
ically, default using the load value of the currently operated channel.
13.23 CH Copy/Coupling
The 4060B Series supports state and waveform copy function between its two channels. That is to say, it copies all
parameters and states (including the channel output state) and arbitrary waveform data of one channel to the other one.
Press Utility → CH Copy Coupling → Channel Copy, to enter the following interface.
CH1=>CH2 Copy all parameters and states of CH1 to CH2.
CH2=>CH1 Copy all parameters and states of CH2 to CH1.
Accept Perform the current selection and return to the Utility menu.
Cancel Give up the current selection and return to the Utility menu.
Note: Channel coupling or track function and channel copy function are mutually exclusive. When channel coupling
or track function is enabled, the menu Channel Copy is hidden.
13.23.1 Channel Coupling
The 4060B Series supports frequency, amplitude and phase coupling. Users can set the frequency deviation/ratio,
amplitude deviation/ratio or phase deviation /ratio of the two channels. When coupling is enabled, CH1 and CH2 can
be modied simultaneously. When the frequency, amplitude or phase of one channel (as the reference) is changed, the
corresponding parameter of the other channel will be changed automatically and always keeps the specied frequency
deviation/ratio, amplitude deviation/ratio or phase deviation /ratio relative to the base channel.
Press Utility → CH Copy Coupling → Channel Coupling, to menu.