User Manual
Utility Function 64
Output Default
Function Sine Wave
Frequency 1kHz
Amplitude/Oset 4Vpp/0Vdc
Phase 0°
Load High Z
Modulation Default
Carrier 1kHz Sine Wave
Modulating 100Hz Sine Wave
AM Depth 100
FM Deviation 100Hz
ASK Key Frequency 100Hz
FSK Key Frequency 100Hz
FSK Hop Frequency 1MHz
PSK Key Frequency 100Hz
PM Phase Deviation 100°
PWM Width Dev 190s
Sweep Default
Start/Stop Frequency 500Hz/1.5kHz
Sweep Time 1s
Trig Out O
Mode Linear
Direction ↑
Burst Default
Burst Period 10ms
Start Phase 0°
Cycles 1Cycle
Trig Out O
Delay 521ns
Trigger Default
Source Internal
Table 13.1 Default Settings
3. Select the rmware le (.ADS) and choose Recall to update the system software.
4. After the updating is nished, the generator will restart automatically.
Note: Powering o the generator during a rmware update can corrupt the unit.
Note: A confmguration le (.CFG) may or may not be included with a given rmware update. If a CFG le is not
included with a rmware update then it will not be required for that update.
13.10 Built-in Help
The 4060B Series provides a built-in help system, by which users can view the help information at any time when operating
the instrument. Press Utility → System → Page 1/2 → Help to enter the following interface.
UP Cursor upward to select.