User Manual
Utility Function 63
Figure 13.4 Chinese Interface
the instrument is powered on. This setting is stored in non-volatile memory and will not be inuenced by the Set To
Default operation.
Last includes all system parameters and states, except channel output state.
Default denotes the factory defaults except certain parameters (such as Language).
13.5 Set to Default
Press Utility → System → Set To Default, to set the system to the default setting. The default settings of the system
are as shown in Table 13.1.
13.6 Beep
Enable or disable the beeper. Press Utility →System → Beeper to select “On” or “O” and the default is “On”.
13.7 Screen Saver
Enable or disable screen saver. Press Utility → System → Page 1/2 → ScrnSvr to select “On” or “O” and the default
is “O”. Screen saver will be on if no action is taken within the time that you have selected. Click the touch screen or
Press any key to resume.
13.8 System Info
Select the System Info option of the utility menu to view the generator’s system information, including startup times,
software version, hardware version, model and serial number.
13.9 Software Update
The software version and conguration le of the generator can be updated directly via U-disk. Follow the steps below:
1. Insert U-disk with rmware update le (.ADS) and conguration le (.CFG) to USB host interface on the front panel
of the generator.
2. Press Utility → Page 1/2 → Firmware Update. Or press Store/Recall directly.