User Manual

Burst Function 53
Function Explanation
Delay Set the delay time before the burst starts.
Trig Out O Disable trigger out.
On Enable trigger out.
Page 2/2 Return to the previous page.
Figure 11.2 N-Cycle Burst Interface (Page 2/2)
11.1.2 Innite
In innite mode, the cycle number of the waveform is set as an innite value.
The generator outputs a continuous waveform after receiving the trigger signal. Waveforms that support innite mode
include sine, square, ramp, pulse and arbitrary.
Press Burst → NCycle → Innite, and set the trigger source to “external” or
“manual”. The screen will display an innite cycle burst, as shown in Figure 11.3.
Figure 11.3 Innite Burst Interface
11.1.3 Gated
In gated mode, the generator controls the waveform output according to the gate signal level. When the gated signal
is “true”, the generator outputs a continuous waveform. When the gated signal is “false”, the generator rst completes
the output of the current period and then stops. Waveforms that support gated burst include sine, square, ramp, pulse,
noise and arbitrary.