User Manual

Sweep Function 51
Figure 10.3 Linear Sweep Interface
Figure 10.4 Log Sweep Interface
8 Internal Trigger
Choose Source → Internal, the generator outputs continuous sweep waveform when internal trigger is selected. The
default is “Internal”. Choose Trig Out → On, the [Aux In/Out] connector at the rear panel will output the trigger signal.
9 External Trigger
Choose Source → External, the generator accepts the trigger signal inputted from the [Aux In/Out] connector at the
rear panel when external trigger is selected. A sweep will be generated once the connector receives a CMOS pulse with
specied polarity. To set the CMOS pulse polarity, choose Edge to select “Up” or “Down”.
10 Manual Trigger
Choose Source → Manual, a sweep will be generated from the corresponding channel when the Trigger softkey is pressed
when manual trigger is selected. Choose Trig Out → On, the [Aux In/Out] connector at the rear panel will output the
trigger signal.