User Manual
Arbitrary Wave 37
Figure 8.2 TrueArb
8.2.1 Sampling Rate
1. Press Waveforms →Page 1/2 →Arb →TureArb →Srate, to set the sampling rate parameter.
The sampling rate shown on the screen when the instrument is powered on is the default value or the set value of last
power on. When setting the function, if the current value is valid for the new waveform, it will be used sequentially.
If you want to set the frequency for the waveform, press SRate/Frequency key again, to switch to the frequency
parameter (the current operation is displayed in inverse color).
2. Input the desired sampling rate.
Use the numeric keyboard to input the parameter value directly, and press the corresponding key to select the parameter
unit. Or you can use the arrow keys to select the digit you want to edit, and then use the knob to change its value.
Figure 8.3 Set the Sampling Rate
Note: The methods of setting the parameters of arbitrary signal are similar to sine waveform function.
8.3 Waveform Selection
There are numerous built-in Arbitrary Waveforms and there is storage for user-dened Arbitrary Waveforms inside the
generator.