User Manual

Noise Wave 33
2. Input the desired stdev.
Use the numeric keyboard to input the parameter value directly, and press the corresponding key to select the parameter
unit. Or use the arrow keys to select the digit to edit, and then use the knob to change its value.
6.2 Mean
Figure 6.3 Setting the Mean
1. Press Waveforms → Noise → Mean, to set the mean.
The mean shown on the screen when the instrument is powered on is the default value or the set value of last power
down.
2. Input the desired mean.
Use the numeric keyboard to input the parameter value directly, and press the corresponding key to select the parameter
unit. Or use the arrow keys to select the digit to edit, and then use the knob to change its value.
6.3 Bandwidth
Figure 6.4 Setting the Bandwidth