User Manual

Sine Waveform
Press the “Waveforms” key and then press the Sine softkey. The screen shown in Figure 2.1 will open. The parameters
available for sine waveforms include frequency, period, amplitude, high level, low level, oset and phase.
Parameter Description
Frequency/Period Set the signal frequency or period; The current parameter will be switched at a second press.
Amplitude/HighLevel Set the signal amplitude or high level; The current parameter will be switched at a second press.
Oset/LowLevel Set the signal oset or low level; The current parameter will be switched at a second press.
Phase Set the phase of the signal.
Figure 2.1 Sine Wave Parameters
2.1 Frequency/Period
Frequency is one of the most important parameters of basic waveforms. For dierent instrument models and waveforms,
the available ranges of frequency are dierent. For detailed information, please refer to “4060B Series Datasheet”. The
default frequency is 1 kHz.
1. Press Waveforms → Sine → Frequency, to set the frequency parameter. The frequency shown on the screen when the
instrument is powered on is the default value or the set value of last power down. If Period (rather than Frequency) is
the desired parameter, press Frequency/Period again to enter the Period mode. The current value for the waveform’s
period is now displayed in inverse color. Press the Frequency/Period key once again to return to the Frequency entry
mode.
2. Input the desired frequency.
Use the numeric keyboard to input the parameter value directly, and press the corresponding key to select the parameter
unit. Or use the arrow keys to select the digit to edit, and then use the knob to change its value.
Note: When using the numeric keyboard to enter the value, the left arrow key can be used to move the cursor
backward and delete the value of the previous digit.
2.2 Amplitude
The amplitude setting range is limited by the “Load” and “Frequency/Period” settings. For detailed information, please
refer to “4060B Series Datasheet”.