User Manual

Quick Start 12
Page 1
Page 2
Figure 1.4 Waveform Menu
1.5.1 Frequency and Phase
To set the frequency, press the rst soft-key, the frequence value to the right of the waveform, or the word “frequency”
above the rst soft-key. The eld, when ready for editing, is highlighted in blue as shown in Figure 1.5. Use the knob,
arrow keys, and the number pad to set the desired frequency. As the value is changed the output will follow the changes
as they occur if the output is on. Phase is modied in the same manner.
Figure 1.5 Frequency Setting
1.5.2 Amplitude, and Oset
Like setting the frequency, select the parameter to modify and use the knob and keys to change its value. The oset and
amplitude are related through the eective maximum and minimum voltages. The waveform output is fully dened by
either setting the amplitude and oset, or the high and low level. The high and low level dene the peak values of the
waveform.