User Manual

65
configured during the last power-on state. This function can be used to retain instrument
configurations in the case of power interruptions.
Press the PowerOn option from the menu to select between Default and Last.
Default will load default instrument settings during power up.
Last will load instrument settings from the last power up state.
Note: The output states of both channels cannot be recalled at power-on. For safety
reasons, the states are disabled by default.
Set to Factory Default
You can set the instrument settings to factory default by selecting Set to Default. The
instrument will change all settings to default, and the screen will return to the main display
with Sine wave active.
Below is a table of the factory default settings:
Parameters
Default Settings
Function
Sine Wave
Frequency
1.000000 kHz
Amplitude
4 Vpp
Offset
0 V
Phase
0 °
Output Impedance
HighZ
Modulation
Carrier Frequency
1.000000 kHz
Modulating Frequency
100 Hz
Modulation Shape
Sine Wave
AM Depth
100 %
FM Deviation
500 Hz
Key Frequency
100 Hz
FSK Hop Frequency
1 MHz
Phase Deviation
180 °
Sweep
Start/Stop Frequency
100 Hz/1.9 kHz
Sweep Time
1 second
Trig Out
Off
Mode
Linear
Direction
↑
Burst
Period
10.000 ms