User Manual

CHAPTER 10. STATISTICS 26
Parameters 0 to 2.2E+6 units Ω
Example stat:upper 100e-3
ery Syntax STATistics:UPPer?
Returned Parameters <nr3>
10.4 STATistics:LOWer
Description The lower comparison limit when in Absolute Tolerance mode.
Note If statistics is active (STATistics[:STATe] on) this command is ignored and
the value le unchanged. Disable statistics to enable changeability.
Command Syntax STATistics:LOWer <nr3>
Parameters 0 to 2.2E+6 units Ω
Example stat:lower 50e-3
ery Syntax STATistics:LOWer?
Returned Parameters <nr3>
10.5 STATistics:REFerence
Description The nominal or reference value to use for comparison.
Note If statistics is active (STATistics[:STATe] on) this command is ignored and
the value le unchanged. Disable statistics to enable changeability.
Command Syntax STATistics:REFerence <nr3>
Parameters 0 to 2.2E+6 units Ω
Example stat:ref 75.0e-3
ery Syntax STATistics:REFerence?
Returned Parameters
10.6 STATistics:PERCent
Description The percent deviation from the reference value to use for comparison.
Note If statistics is active (STATistics[:STATe] on) this command is ignored and
the value le unchanged. Disable statistics to enable changeability.
Command Syntax STATistics:PERCent <nr2>
Parameters 0 to 99.999%
Example stat:percent 10
ery Syntax STATistics:PERCent?
Returned Parameters <nr2>