User Manual

33
Figure 19 - COMP DISP Menu Tree
3.2.1 OPTIONS
The OPTIONS key allows the user to access the additional comparator option menu.
The options are:
 DISP (ON/OFF): Toggle the measurement results display on and off
 COMP BEEP (OFF/NG/GD): Toggles beep between off, not good (NG) and good (GD).
 COUNT (ON/OFF): ON begins the comparator count if COMP is ON. Count increments
based on trigger settings. OFF stops the count.
 COUNT CLEAR: HI, LO, IN, and TOT counts are reset to 0.
 DISP MODE: Toggle between NORMAL and DEV modes. NORMAL shows the resistance
measurement. DEV shows a percentage (∆) based on the following equation:
∆ = (Measured Resistance – Nominal Value) / Nominal Value x 100%
3.2.2 COMP
The COMP key turns the comparator functions ON and OFF. Results are in the results display
area. COMP: NC will be displayed if COMP is OFF.
3.2.3 COMP MODE
The COMP MODE key allows the user to access two comparator modes.
 % (Percent Error): The user can set the nominal value (NOM) and the percent error (%).
If the nominal value is 100 and percentage is 10, the tolerance will be 100±10%. The
COMP DISP
OPTIONS
DISP
COMP
BEEP
COUNT
COUNT
CLEAR
DISP
MODE
COMP
OFF
ON
COMP
MODE
%
NOM
%
ABS
HIGH
LOW