User Manual

3.1.2 FUNC

The FUNC key allows the user to measure resistance in normal or low voltage modes.

The measurement modes are:

 R: Resistance

 LPR: Resistance tested at low voltage

3.1.3 RANGE

There are 2 resistance measurement modes:

1. Measurement Mode (R) with 7 ranges:

2. 20 mΩ, 200 mΩ, 2 Ω, 20 Ω, 200 Ω, 2 kΩ, 20 kΩ

3. Measurement Mode at Low Voltage (LPR) with 4 ranges:

4. 2 Ω, 20 Ω, 200 Ω, 2 kΩ

Follow the instructions below to set the resistance measurement ranges.

1. Touch the RANGE key, the following menu options will be displayed:

 AUTO: Automatically selects the range mode depending on the resistance

detected.

 HOLD: Lock to the current resistance measurement range.

 ↑ (+): Increase measurement range and sets the measurement to HOLD.

 ↓ (-): Decrease measurement range and sets the measurement to HOLD.

3.1.4 SPEED

The SPEED key controls the measurement time. In SLOW1 and SLOW2 mode noise is lower but

measurement time is increased. FAST mode performs high speed measurements but with

increased noise. See 1.1 for timing details.

Follow the instructions below to set the measurement speed.

1. Touch the SPEED key, the following menu options will be displayed:

 FAST

 MED

 SLOW1

 SLOW2

Note: In SLOW2, SLOW1 or MED mode the display measurement is 5 digits. FAST mode is 4 digits.