User Manual

2.3 Input Connections

The instrument uses 4-terminal Kelvin test clips to measure more accurately and attain a higher

level of performance than 2-terminal clips. Connect the cable to HI and LO terminals on the

instrument front panel. Check the color and alignment arrows conformity of the test fixture

with that of the connectors (see Figure 8). Do not insert the connectors vertically as this will

cause inaccurate measurements (see Figure 9).

Figure 8 - Connection Alignment

Figure 9 - Do Not Connect Vertically

2.4 Preliminary Check

Complete the following steps to verify that the instrument is ready for use.

1. Verify AC Input Voltage

Verify and check to make sure proper AC voltages are available to power the instrument. The

AC voltage range must meet the acceptable specification as explained in Input Power

Requirements.

2. Connect Power

ALIGNMENT ARROWS