User Manual

 The line voltage selector is the fuse holder that contains the fuse. Follow the step above

to remove the fuse box.

 The grey colored piece is the fuse holder and the line voltage selector. To change the

line voltage configuration between 110 V and 220 V, pull this piece out of the fuse box

and rotate it 180 degrees.

 Place it back in the fuse box. The front of the fuse box has an opening, which should

indicate the line voltage you configured. It should display either 110 or 220. If neither

of these labels is shown in the fuse box opening, pull out the fuse holder and turn it

again until it shows the line voltage configuration desired.

Figure 7 - Rotate to line voltage

Any disassembling of the case or changing the fuse not performed by an authorized service

technician will void the warranty of the instrument.

Fuse

Fuse holder

Fuse box opening