User Manual

113
4.4.5 Bus Mode
Press Bus Mode to select the communication interface in the menu options. All interfaces are
accessible on the rear panel.
 RS232C
 LAN
 USBTMC
 USBVCOM
4.4.6 Baud Rate
Press Baud Rate to select from the following six baud rates:
 9600
 19200
 28800
 38400
 57600
 115200
4.4.7 EOC Signal
The EOC signal can be found on handler pin 12. The End of Conversion signal is pulled low at the
beginning of measurement and pulled high at the end of all instruments internal calculations.
EOC enables the user to select between HOLD and PULSE modes. HOLD will keep the EOC signal
high, waiting for the next trigger. In PULSE mode the EOC signal pulse width is manually
controlled. The user can manually set the with PULSE mode:
1. Press PULSE
2. Press Input for open a numeric keypad.
3. Set pulse width. Range: 0 ms – 100 ms.