User Manual

105
 MANU: Detection time manually set.
 INPUT: Opens numeric keypad to modify manual detection timing.
4.1.9 Meas Mode
The instrument has an internal 10 nF capacitor that can be connected or disconnected across
the terminals. Commonly used when measuring large resistors and inductors. The user can
select between the following modes:
 SLOW: Connects the 10 nF capacitor across the test terminals.
 FAST: Disconnects the 10 nF capacitor across the test terminals.
4.1.10 Adjust
Internal instrument corrections are controlled by Adjust. These corrections take 55ms. The user
can select between the following modes:
 AUTO: Enable the instrument to automatically make corrections every 30 minutes.
 MANU: Corrections occur only when manually triggered by  handler pin 29.
4.2 Temperature Compensation (TC/∆t) Setup
The TC/∆t SETUP page is where the user can enable the temperature compensation functions,
modify temperature calculation parameters, and select the temperature probe type. The
connector is a ¼ inch shielded jack. To access the page press the SETUP button and select TC/∆t
SETUP in menu options.
Figure 54 - TC/∆t setup