User Manual

Chapter 10
STATistics
10.1 STATistics[:STATe]
Description The state of the statistics function. Prior to enabling statistics, the display
page must be on statistics. See section 2.1
Command Syntax STATistics[:STATe] <bool>
Parameters 1, on, 0, or o
Example stat on
ery Syntax STATistics[:STATe]?
Returned Parameters 1 for on and 0 for o
10.2 STATistics:MODE
Description The “edge” or limit mode to use.
Note If statistics is active (STATistics[:STATe] on) this command is ignored and
the value le unchanged. Disable statistics to enable changeability.
Command Syntax STATistics:MODE <str>
Parameters ATOLerance or PTOLerance
Example stat:mode atol
ery Syntax STATistics:MODE?
Returned Parameters PTOL or ATOL
10.3 STATistics:UPPer
Description The upper comparison limit when in Absolute Tolerance mode.
Note If statistics is active (STATistics[:STATe] on) this command is ignored and
the value le unchanged. Disable statistics to enable changeability.
Command Syntax STATistics:UPPer <nr3>
25