User Manual

152
 If the D0~D7 softkey is set to Custom, press the Custom softkey and turn the Universal
Knob to select the desired value (-3 V to 3 V) and push the knob to confirm.
16.7 Displaying Digital Channels as a Bus
Digital channels may be grouped and displayed as an 8-bit bus, with each value displayed at the
bottom of the display in hex or binary. You can have one or two buses.
To configure and display each bus, follow these steps:
1. Press the Digital button to open the DIGITAL menu and display the digital channel waveforms.
2. Press the Digital Bus softkey to enter the DIGITALBUS menu.
Figure 132 - DIGITALBUS menu
3. Press the Bus Select softkey to select Bus 1 or Bus 2. Selecting Bus 1, for example, will show
the B1 bus display in blue at the bottom of the screen just above the softkeys.
4. Press the System Display softkey to choose Hex, Binary, or Decimal to display the number
represented by the channel inside the B1 or B2 display.
5. A digital status indicator is displayed immediately above the right-most softkeys. A blue box
means the channel is included in the bus. Dark gray means it is excluded from the bus. The
channel with the red box is shown in red on the screen.
The Sampling rate of the digital channels is displayed at the right of the display under the analog
channel information.