User Manual

13
Using Programming Features
5.1 Preset Program
1. Press Program .
2. Use the numeric keypad thru to select a preset voltage and current value.
3. Use and to adjust preset voltage and current values.
4. Press within 3 seconds to conrm or press to exit program setting.
5.2 Setting Timed Program
The unit can be programmed to operate up to 20 timed subprograms (0-19 STEP as shown in the display). Each
subprogram is capable of running a preset operation period of 1 second to 99 minutes and 99 seconds with its own preset
voltage and current level. The timed subprogram can be set to run in sequence repeatedly from 1 to 9999 cycles or
innity run. You can run the unit through the sequence of subprograms for the input cycles number unless interrupted
by pressing the CLEAR key.
1. Press then press on the numeric keypad to enter program setting menu.
2. Use to select a step to be modied.
3. Use the up and down keys to navigate between setting voltage, current, and time
4. Press Enter to conrm and exit.
5.3 Run Timed Programming
1. Press then press to select step program to run
2. Use to select the number of steps to run (2 to 20) and press .
Ex. Selecting step 3 means run from step 1 to step 3
3. Input the desired number of cycles from 0000 to 9999 using the numeric keypad or rotary knob, press to
conrm and begin timed program. Leave this setting on 0000 for innite cyclic run. Press to
terminate the program.