Owner manual

and full information for ISP implementation. For example: description of ISP connector pins
for currently selected chip, recommended target design around in-circuit programmed chip.
The reserved key <Ctrl+F1> will bring out this menu from any menu and any time
immediately.
Programmer
Menu Programmer includes commands used for work with programmers.
Programmer / Find programmer
This item selects a new type of programmer and communication parameters. This command
contains following items:
Programmer - sets a new type of programmer for find. If a Search all is selected, the control
program finds all supported programmers.
Establish communication - allows manual or automatic establishing communication for a
new programmer.
Speed - sets speed, if a manual establishing communication is selected, which PC sends
data into the programmer. Speed is expressed as a percent from a maximal speed.
Port - selects a port, which will be scanned for a requested programmer. If All port is
selected, the control program scans all ports, which are available on standard addresses.
Address for special port - sets address of LPT port, if a Special port is selected.
Pressing key <Enter> or button OK initiates scanning for programmer by set parameters.
There is same activity as at start the control program. The command clears a list of default
devices without the current device, if the new selected programmer supports this one.
This setting is saved to disk by command Options / Save options.
96