Owner manual

Technical specification

HARDWARE

Base unit, DACs

• USB 2.0 high-speed compatible port, up to 480 Mb/s transfer rate

• on-board intelligence: powerful microprocessor and FPGA based state machine

• three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time

• VCCP range 0..8V/1A

• VPP1, VPP2 range 0..26V/1A

• selftest capability

• protection against surge and ESD on power supply input, parallel port connection

• banana jack for ESD wrist straps connection

• banana jack for connection to ground

Socket, pindriver

• 48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 48-pin

• pindrivers: 48 universal

• VCCP / VPP1 / VPP2 can be connected to each pin

• perfect ground for each pin

• FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins

• analog pindriver output level selectable from 1.8 V up to 26V

• current limitation, overcurrent shutdown, power failure shutdown

• ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)

• continuity test: each pin is tested before every programming operation

ISP connector

• 20-pin male type with miss insertion lock

• 6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to

5V to handle all (low-voltage including) devices.

• 1x VCCP voltage (range 2V..7V/100mA)

• programmed chip voltage (VCCP) with both source/sink capability and voltage sense

• and 1x VPP voltage (range 2V..25V/50mA)

• Target system power supply voltage (range 2V..6V/250mA)

• ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8kV contact)

• two output signals, which indicate state of work result = LED OK and LED Error (active

level: min 1.8V)

• input signal, switch YES! equivalent (active level: max 0.8V)

DEVICE SUPPORT

Programmer, in ZIF socket

• EPROM: NMOS/CMOS, 27xxx and 27Cxxx series, with 8/16 bit data width, full support for

LV series