Owner manual

Connecting 866C to the PC

Using USB port

In this case, order of connecting USB cable and power supply to programmer is irrelevant.

Problems related to the 866C



PC interconnection, and their

removing

If you have any problems with 866C  PC interconnection, see section Common notes

please.

Manipulation with the programmed device

After selection of desired device for your work, you can insert into the open ZIF socket (the

lever is up) and close socket (the lever is down). The correct orientation of the programmed

device in ZIF socket is shown on the picture near ZIF socket on the programmer's cover. The

programmed device is necessary to insert into the socket also to remove from the socket

when LED BUSY light off.

Note: Programmer's protection electronics protect the target device and the programmer

itself against either short or long-term power failures and, partly, also against a PC failure.

However, it is not possible to grant the integrity of the target device due to incorrect, user-

selected programming parameters. Target device may be not destroyed by forced interruption

of the control program (reset or switch-off PC), by removing the physical connection to the

programmer, but the content of actually programmed cell may remains undefined. Don't

unplug the target device from the ZIF socket during work with device (LED BUSY shine).

In-system serial programming by 866C

For general definition, recommendation and direction about ISP see section Common notes

/ ISP please.

Description of ISP connector

As ISP connector is used 20 pins connector 2-1634689-0 from TE connectivity or other

compatible connector.